1、The design and fabrication of BAW delay lines with ultra short delay time are described.
敘述了超短延時聲體波微波延遲線的設計和制作。

2、Adjusting delay time and gas pressure can reduce the warpage of the part.
工藝上可以通過調整延遲時間和氣體壓力來減小產品的變形量。

3、DELAY TIME : The inadvertent delay in the manufacturing of product; production temporarily stopped.
延期：是指產品制造過程中的延遲，生產暫時停止。

4、Delay time will affect its dry density.
延遲時間影響其干密度。

5、Usually, 50-100 ms delay time is normal.
通常來講，50- 100毫秒的延遲時間都屬于正常的范圍。

6、Its power dissipation and propagation delay time are a tradeoff of the two comparators.
其功耗和傳輸延遲時間介于兩種比較器之間。

7、The relation of the couple range and the delay time are discussed.
也給出了同步時耦合參數范圍和時間延遲的關系。

8、The delay time between plating completion and baking start typically is observed.
電鍍后和烘焙開始之間的間隔時間一定要嚴格控制。

9、Analysis and modeling of delay time in industrial Ethernet
工業以太網時延分析與建模研究

10、NUMERICAL SIMULATION OF REEMISSION DELAY TIME OF Au DISK HEATED BY X RAYS
X光加熱金平面靶再發射時間的數值模擬

11、The ignition temperature and ignition delay time decreased with the increasing radiant heat flux.
結果表明，隨著輻射熱能流率的增加，著火時間縮短，著火溫度降低；

12、Add delay time between each virtual user, user "think time," and statistical-level Settings.
添加每一個虛擬用戶之間的延遲時間(單位是微秒)、用戶“思考時間”和統計級別的設置。

13、Interestingly, delay time is a big factor in choosing an alternative.
有意思的是，在決定要做出什么樣的選擇時，拖延的時間才是最重要的因素。

14、The rotational delay time from a disk file
磁盤文件的轉動延遲時間。

15、The influence of delay time on the dynamics of the system.
延遲時間對系統動力學的影響。

delay time翻譯

【計】 延遲時間【經】 延期時間, 推遲時間 詳情