1、For cancer drugs, tumor shrinkage is considered a predictor of increased survival.
對癌癥藥物來講，能夠使腫瘤收縮被認為是增加生存機會的預言者。

2、The reality is that balance sheet shrinkage is best deferred until markets improve.
實際上，最好的選擇是等市場好轉之后再縮小資產負債表。

3、Durable, white, water - resistant, low shrinkage resin for stereo lithography for SLA system.
應用于立體光刻技術的耐久性，白色，防水和低收縮的樹脂。

4、There has been much shrinkage of the clothes in the wash.
這些衣服洗后已縮了很多。

5、It is better to allow for shrinkage when buying cotton clothes.
買棉衣時最好要考慮到它們的縮水率。

6、Solve the problem of internal shrinkage of magnesium iron foundry.
解決球鐵鑄造內部縮孔問題。

7、Centerline shrinkage is the main defect that affects the inner quality of continuous casting slab.
連鑄坯內部中心縮松、縮孔是影響鑄坯內部質量的主要缺陷之一。

8、Inspect interior walls for shrinkage damage.
檢查一下內墻，看是否有干縮損壞。

9、Shrinkage strains are mdependent of the stress conditions in the concrete.
混凝土的收縮是一種自發的變形，并不依靠作用在混凝土上的外力。

10、Shrinkage Prediction of Locomotive Long Hub Core Casting
機車長轂輪芯鑄件縮孔縮松預測

11、Surface of the adaptor case should no scratch,. no shrinkage mark, flash and mechnical damage.
外殼表面應平整無劃痕、縮水紋、毛刺及其它機械損傷。

12、Some patients have also had shrinkage of their tumors (partial response).
一些患者的腫瘤已有縮?。?a href="/zaoju/712138.htm">部分反應）。

13、It is indicated the said crack is due to too small shrinkage ratio of the compacting die.
指出，拉絲模內孔之所以產生裂紋，是由于壓模收縮比太小的原因。

14、Analysis of Shrinkage Mark on Ribs of GMT Parts
GMT制品加強筋表面縮痕成因分析

15、The impacts of transverse and longitudinal shrinkage of welding seam on underframe positioning.
以及焊縫橫向、縱向收縮對底架定位的影響。

16、When making clothes, you must allow for the shrinkage of these materials.
你做衣服時，必須考慮到這些布料的縮水性。

17、Analysis on Shrinkage Cracks of the Long Concrete Wall
混凝土長墻收縮裂縫分析

18、The feasibility for producing high shrinkage acrylic fiber polymer by existing process was studied.
分析探討了采用現有工藝生產高收縮腈綸聚合物的可行性；

19、They also undergo a high shrinkage or reduction in volume during solidification.
它們在固化過程中收縮較大或體積減少較多。

20、the rate of shrinkage in size or number.
在尺寸或數目上收縮的比率。

21、We can control the shrinkage according to your request.
我們縮水率可以做到你要求的。

22、Study on Eddy Current Method for Concrete Early Age Shrinkage Measurement
混凝土早齡期收縮測試電渦流法的研究

23、The volume shrinkage of the sample was lowed from 7% to 0.8%, which apparently smoothen the film.
特別是樹脂的固化體積收縮率顯著降低，從7％下降到0.8％，明顯改善了涂膜的平整性。

24、Shrinkage cavity predication is main purpose of casting simulation.
預測縮孔缺陷產生是鑄件凝固模擬的主要目的。

25、The shrinkage of the base decreases by the proper dosage water reducing agent.
適宜用量的減水劑降低了基層材料的收縮量。

26、STUDY ON SHRINKAGE OF CDP-FDY FIBER AT DIFFERENT DRAWN TEMPERATURE
拉伸溫度對CDP-FDY纖維收縮性能的影響

27、The shrinkage movement can be transformed temperate difference at equivalence relation.
收縮變形可用溫度應力的概念換算為當量溫差。

28、Study on hot water shrinkage rate of PTT and PBT filaments
PTT與PBT長絲的熱水收縮性能比較

29、The main deformity of the center housing cast in the automobile turbocharger is shrinkage cavity.
在汽車渦輪增壓器中心架鑄件生產中主要產生縮孔缺陷。

30、High shrinkage PAN bulk top are produced by using the process of "drawing to break".
論述了用拉斷法直接制條生產高縮率腈綸膨體紗毛條的生產工藝。

shrinkage翻譯

n. 收縮, 收縮量, 減低【化】 起皺; 收縮; 收縮量【醫】 皺縮; 皺縮度 詳情